HP Surestore 2.15 Tape Library - Manual (Page 42)

2-16
Library Installation
Moving or Shipping the Library
6. If the library is rack mounted:
a. Extend the antitip rail on the rack.
WARNING Failure to extend the antitip rail could result in personal injury
and/or damage to the library if the rack tips over.
b. Slide the library out of the rack so that it is in the fully extended
position.
c. Reattach the handles to the side of library using two screws. Make
sure the handle flanges are on top of the slides. (The handles and
hardware for reattaching them should have been saved with the
original shipping materials. If they are missing, call your service
representative for assistance in getting replacement handles.)
d. Remove the three 8-32 screws on each side of the library that secure
the library to the rack slides.
7. IMPORTANT — two people needed: With a person on each side of the
library, lift the library onto a cart.
8. Transport the library:
• To move the library a short distance, roll the cart to the new location.
• To ship the library, repackage the library in the same materials and
ship it in the same manner in which it was received, then unpack it at
its new destination.
CAUTION The library can be seriously damaged if it is not shipped using appropriate
shipping materials. A service representative can provide assistance or advice
on how to best repackage and ship the library.
9. Re-install the library. Refer to installation steps 3 through 8 in this chapter.