HP ProLiant DL380 G3 Server - Manual (Page 71)

Hardware Options Installation 71
•
•
•
•
Install only PC2100 Registered DDR SDRAM DIMMs, 2.5 volts, 72 bits
wide, and ECC.
Install DIMMs with the same speed.
Install DIMMs into both slots within a single bank. Install DIMMs in order.
Upgrade memory by installing DIMM pairs into banks in sequential bank
order, starting with bank B.
For online spare memory support, you must also observe additional guidelines
("Online Spare Memory Configuration" on page 70).
Installing DIMMs
1. Power down the server ("Powering Down the Server" on page 37).
2. Extend the server from the rack, if applicable ("Extending the Server from
the Rack" on page 38).
3. Remove the access panel ("Removing the Access Panel" on page 40).
4. Open the DIMM slot latches.
5. Install the DIMM.
6. Install the access panel ("Installing the Access Panel" on page 40).
HP CONFIDENTIAL
File Name: 303130-3.doc Last Saved On: 7/7/03 1:48 PM