HP ProLiant DL380 G3 Server - Manual (Page 118)

118 HP ProLiant DL380 Generation 3 Server User Guide
Configuring Online Spare Memory
To configure online spare memory:
1. Install the required DIMMs ("Memory Options" on page 69).
2. Access RBSU by pressing the F9 key during powerup when the prompt is
displayed in the lower right corner of the screen.
3. Select System Options.
4. Select Advanced Memory Protection.
5. Select Online Spare with Advanced ECC Support.
6. Press the Enter key.
7. Press the Esc key to exit the current menu or press the F10 key to exit
RBSU.
For more information on online spare memory, refer to the white paper on the HP
website
(
http://www.compaq.com/support/techpubs/whitepapers/tm010301wp.html ).
Re-Entering the Server Serial Number
After you replace the system board or clear NVRAM, you must re-enter the
server serial number.
1. During the server startup sequence, press the F9 key to access RBSU.
2. Select the System Options menu.
3. Select Serial Number. The following warning is displayed:
WARNING! WARNING! WARNING! The serial number is loaded
into the system during the manufacturing process and
should NOT be modified. This option should only be used
by qualified service personnel. This value should always
match the serial number sticker located on the chassis.
4. Press the Enter key to clear the warning.
5. Enter the serial number and press the Enter key.
6. Press the Escape key to close the menu.
HP CONFIDENTIAL
File Name: 303130-3.doc Last Saved On: 7/7/03 1:48 PM