HP ProLiant DL380 G3 Server - Manual (Page 130)

130 HP ProLiant DL380 Generation 3 Server User Guide
Server Error Messages
The following POST error messages are new to some ProLiant servers. For a
complete listing of error messages, refer to the Servers Troubleshooting Guide on
the Documentation CD.
Error Code Audible
Beeps Possible Problem Possible Action
207-Memory Configuration
Warning - DIMM In DIMM Socket
X does not have Primary Width of
4 and only supports standard
ECC. None Installed DIMMs have
a primary width of x8. Install DIMMs that have a
primary width of x4.
209-Online Spare Memory
Configuration - Spare bank is
invalid. Mixing of DIMMs with
Primary Width of x4 and x8 is not
allowed in this mode. One long
and one
short Installed DIMMs for
online spare bank are
of a different primary
width than the DIMMs
in other banks. Install or reinstall DIMMs
to support online spare
configuration.
A mixture of 533 MHz and 400
MHz Front Side Bus Speed
Processors Detected! Please
make sure that all Processors
have the same Front Side Bus
Speed. - System Halted. One long
and one
short Processors have
different front side bus
speeds. Install processors with
the same front side bus
speed.
This system only supports 400
MHz Front Side Bus Speed
Processors. One or more 533
MHz Front Side Bus Speed
Processors have been initialized
at 400 MHz. One long
and one
short Front side bus speed
of 533 MHz is not
supported by the
server model. None. The system will
run at the supported front
side bus speed of 400
MHz.
When the Server Does Not Start
This section provides systematic instructions on what to try and where to go for
help for the most common problems encountered during initial POST. The server
must first complete this test each time you power up, before it can load the
operating system and start running software applications.
If the server does not start:
HP CONFIDENTIAL
File Name: 303130-3.doc Last Saved On: 7/7/03 1:48 PM