HP Jetdirect 280m 802.11b Wireless Print Server - Manual (Page 174)

ENWW
HP Jetdirect Configuration Page 33
50 TFTP LOCAL
ERROR The TFTP transfer of the configuration file from the host to
the HP Jetdirect print server failed with the local print server
encountering some form of inactivity timeout, or excessive
retransmissions situation.
51 TFTP RETRIES
EXCEEDED The overall retrying of the TFTP transfer of the configuration
file from the host to the HP Jetdirect print server has
exceeded a retry limit.
52 BAD BOOTP/DHCP
REPLY An error was detected in the BOOTP or DHCP reply that the
HP Jetdirect print server received. The reply either had
insufficient data in the UDP datagram to contain the
minimum BOOTP/DHCP header of 236 bytes, had an
operation field that was not BOOTPREPLY(0X02), had a
header field that did not match the print servers hardware
address, or had a UDP source port that was not the
BOOTP/DHCP server port (67/udp).
53 BAD BOOTP
TAG SIZE The tagsize in a vendor-specific field in the BOOTP reply
is either 0, or greater than the remaining number of
unprocessed bytes in the vendor-specified area.
54 BOOTP/RARP
IN PROGRESS The HP Jetdirect print server is currently in the process of
obtaining its basic IP configuration information through
BOOTP/RARP.
55 BOOTP/DHCP
IN PROGRESS The HP Jetdirect print server is currently in the process of
obtaining its basic IP configuration information through
BOOTP/DHCP, and has not detected any errors.
56 DHCP NAK The HP Jetdirect print server received a negative
acknowledgement message from the DHCP server in
response to a configuration request.
57 UNABLE TO
CONNECT DHCP SVR The HP Jetdirect print server had received IP parameters
from a DHCP server, but communication with the DHCP
server has been lost. Check status of the DHCP server.
If an infinite lease was assigned, the print server will use the
IP address of the most recent DHCP server used, but
operation may be degraded until a DHCP server responds.
58 POSTSCRIPT
MODE NOT
SELECTED The printer does not support AppleTalk or AppleTalk
extensions.
59 INCOMPLETE F/W -
MUST DOWNLOAD Firmware download message. Currently downloading
firmware to the HP Jetdirect print server, or the download
did not complete properly.
5A TURN PRINTER
OFF / ON Firmware download message. Download of firmware is
complete. Power cycle the HP Jetdirect print server.
Table 9.12 Error Messages (9 of 10)
Error Code and
Message Description