HP Jetdirect 280m 802.11b Wireless Print Server - Manual (Page 167)

26 HP Jetdirect Configuration Page
ENWW
0E LAN ERROR -
LOSS OF CARRIER Check the network connections. If the connections are
intact, run the power-on self-test: turn the printer off, then
on again. If the error persists, replace the HP Jetdirect
print server.
10 LAN ERROR -
UNDERFLOW (Ethernet) There may be a problem with your network
cabling or the HP Jetdirect print server. Check the cabling
and connectors on your network. If you cannot find a
problem with your network cabling, run the power-on
self-test: turn the printer off, then on again. If the error
persists, there is a problem with the HP Jetdirect print
server.
10 LAN ERROR-OPEN (Token Ring) The HP Jetdirect print server could not insert
into the ring and join the network. Check the data rate switch
on the HP Jetdirect print server to make sure it is set
correctly.
For information on setting the data rate switch, see the
HP Jetdirect internal print server hardware installation
guides. In addition, check the cabling, external transceiver,
wiring concentrator, and taps.
11 LAN ERROR -
RETRY FAULTS There is a problem with your network cabling or external
network configuration. Verify operation of the hub or switch
port.
12 LAN ERROR -
NO LINKBEAT With a 10/100 Base-TX port connected, this message is
displayed if Link Beat is not sensed. Check the network
cable, and verify that the concentrator/hub is providing Link
Beat.
13 NETWORK
RECONFIG - MUST
REBOOT Reset or power cycle the HP Jetdirect print server to enable
new configuration values.
14 DISCONNECTED The Novell NetWare protocol is disconnected. Check the
server and the print server.
15 CONFIGURATION
ERROR (Ethernet) The configuration information for the NetWare
functions is not stored correctly on the HP Jetdirect print
server. Use the installation software, embedded web server,
or other tools to reconfigure the print server. If this error
persists, there may be a problem with the HP Jetdirect print
server.
15 LAN ERROR - WIRE
FAULT (Token Ring) The HP Jetdirect print server has detected an
open or short circuit in the cable between the HP Jetdirect
print server and the Token Ring wiring concentrator. Verify
that this cable is functional and replace it if necessary.
Table 9.12 Error Messages (2 of 10)
Error Code and
Message Description