Check dimm installation – HP LaserJet M5025 Multifunction Printer series User Manual
Page 280
8.
Replace the formatter cover.
9.
Reconnect the cables, and then turn on the device.
Check DIMM installation
After installing the DIMM, make sure that the installation was successful.
Verify that DIMM is installed correctly
1.
Turn the device on. Check that the Ready light is illuminated after the device has gone through the
startup sequence. If an error message appears, a DIMM might have been incorrectly installed.
See
2.
Print a configuration page (see
).
3.
Check the memory section on the configuration page and compare it to the configuration page that
was printed before the memory installation. If the amount of memory has not increased, the DIMM
might not be installed correctly, or the DIMM might be defective. Repeat the installation procedure.
If necessary, install a different DIMM.
NOTE
If you installed a device language (personality), check the "Installed Personalities and
Options" section on the configuration page. This area should list the new device language.
268
Appendix E Working with memory and print server cards
ENWW