HP StoreAll Storage - Manual (Page 117)

ibrix_httpconfig –a profile1 –h node1,node2 -S
“wblocksize=,rblocksize=”
You can also set the values on the Modify HTTP Profile dialog box:
Managing HTTP from the CLI
On the command line, HTTPis managed by the ibrix_httpconfig, ibrix_httpvhost, and
ibrix_httpshare
commands. The ibrix_httpshare command is also used for creating a
StoreAll REST API-enabled HTTP share. For detailed information, see the HP IBRIX 9000 Storage
CLI Reference Guide .
Configuring HTTP
Add a configuration profile:
ibrix_httpconfig -a PROFILENAME [-h HOSTLIST] [-S SETTINGLIST]
For the -S option, use a comma to separate the settings, and enclose the settings in quotation
marks, such as “keepalive=true,maxclients=200,...”. To see a list of available settings
for the share, use ibrix_httpconfig -L.
Add a virtual host:
ibrix_httpvhost -a VHOSTNAME -c PROFILENAME -I IP-Address:Port [-S
SETTINGLIST]
Add an HTTP share:
ibrix_httpshare -a SHARENAME -c PROFILENAME -t VHOSTNAME -f FSNAME -p
dirpath -P urlpath [-u USERLIST] [-S SETTINGLIST]
For the -S option, use a comma to separate the settings, and enclose the settings in quotation
marks, such as “davmethods=true,browseable=true,readonly=true”.
For example, to create a new HTTP share and enable the WebDAV property on that share:
# ibrix_httpshare –a share3 –c cprofile1 –t dav1vhost1 –f ifs1 –p
/ifs1/dir1 –P url3 –S “davmethods=true”
To see all of the valid settings for an HTTP share, use the following command:
ibrix_httpshare –L
Managing HTTP from the CLI 117