HP Brocade 4Gb SAN Switch for HP BladeSystem c-Class - Manual (Page 54)

NOTE:
If using the CLI, type switchDisable at the prompt. Refer to the Fabric OS
command reference guide for additional command information.
10. Continue with the switch configuration. Enter the appropriate information when
prompted. Make sure that the data entered matches the settings on the faulty switch.
11. Install the same Fabric OS version as the faulty switch using the CLI command
firmwareDownload
, the integrated Web Tools GUI or the optional Fabric
Manager GUI.
12. Verify that the appropriate licenses are installed on the replacement switch.
13. Save the switch configuration file after making your edits, type:
configupload
14. Restore the switch configuration from the remote server using the backup
configuration file from step 1.
15. Enable the switch. Use the CLI command switchenable, the integrated Web
Tools GUI or the optional Fabric Manager GUI.
16. Connect all external FC cables in the same port locations as before. To connect
to the external switch ports without connectivity to external devices, the external
switch port must be disabled prior to inserting the cable and then re‐enabled after
inserting the cable to establish connectivity.
17. Verify that the switch is joined to the fabric and all connected devices log into the
switch, type:
switchshow
18. Save the configuration file.
IMPORTANT:
HP recommends upgrading all switches in the enclosure to the latest available firmware.
Check http://www.hp.com for updates.
54 Managing the 4Gb SAN Switch