HP Brocade 4Gb SAN Switch for HP BladeSystem c-Class - Manual (Page 24)

Install the 4Gb SAN Switch
CAUTION:
For switch revision levels 0A and 0B only (running Fabric OS versions earlier than
5.2.1b) — DHCP is not supported on these models. Do not install multiple switches
at the same time with default addresses, as address conflicts will occur. Locate switch
revision levels on the switch or shipping carton. See Set the IP address .
For switch revision levels 0C and above only (Fabric OS 5.2.1b or later) — DHCP is
supported and enabled by default for switches running Fabric OS 5.2.1b (switch rev
0C) or later. In this case, IP address conflicts will not occur during multiple switch
installations. Locate switch revision levels on the switch or shipping carton. See
Using External DHCP .
The Brocade 4Gb SAN switch is a hot-pluggable device. The enclosure power may be
on or off when inserting the switch. Follow these steps to install the 4Gb SAN Switch.
1. Locate the appropriate interconnect bay in the rear of the enclosure per the
appropriate HP BladeSystem Enclosure Setup and Installation Guide provided with
your enclosure.
Remove the slot cover (if installed).
IMPORTANT:
Populate all enclosure I/O bays with the appropriate component (for
example a switch, Pass-Thru or one of the blank panels provided with
the enclosure).
CAUTION:
Properly ground yourself before handling the switch.
2. Press the handle latch to release the installation handle. See Figure 4 .
24 Setup