HP Brocade 4Gb SAN Switch for HP BladeSystem c-Class - Manual (Page 43)

Table 9 Connecting via a management station
Management
station
First switch Second switch Third switch
Ethernet 192.168.1.09 192.168.1.10 204.1.1.11 204.1.1.12
FCIP 192.168.65.09 192.168.65.10 192.168.65.11 192.168.65.12
Gateway 192.168.1.10 any, not self 192.168.1.10 192.168.1.10
Maintaining the 4Gb SAN Switch
The 4Gb SAN Switch does not require any regular physical maintenance.
However, it is critical that environmental conditions, described in
Environmental
requirements are met to help prevent switch failure due to heat stress or improper air flow.
Installing dust covers in empty ports
The dust covers included in the 4GB SAN Switch shipping carton, (see Figure 1 ) must
be inserted in ports where SFPs are not installed. Installing dust covers ensures proper
airflow and helps reduce dust contamination of the switch.
Replacing an SFP transceiver
In some cases you might need to reinstall an SFP transceiver.
To remove an SFP transceiver:
1. Press and hold the cable release.
2. Remove the cable from the transceiver.
3. Pull the bail (wire handle) to release the transceiver.
4. Grasp the bail, and gently but firmly pull the transceiver out of the port.
5. Repeat this procedure for the remaining ports as required.
Brocade 4Gb SAN Switch for HP c-Class BladeSystem 43