HP Systems Insight Manager User Manual
Page 85
•
5, Critical
•
100, Informational
NOTICEQUERYNAME. The collection name based on how the notice was generated. This value
can say one of the following:
•
This system or event meets the following search criteria: +QueryName
;
•
This system or event now meets the following search criteria:
+QueryName;
•
This system or event no longer meets the following search criteria:
+QueryName;
DEVICENAME. The name of the
that caused the notice.
DEVICEIPADDRESSCOUNT. The number of IP addresses that are mapped to this system.
DEVICEIPADDRESS%d . Based on the count, %d is an integer that shows the actual IP address.
For example:
IF, DEVICEIPADDRESSCOUNT = 2
Then, DEVICEIPADDRESS0 = 111.111.111.111
DEVICEIPADDRESS1 = 222.222.222.222
DEVICEMACADDRESSCOUNT. The number of MAC addresses collected for the system. Before
this information is available, you must run a Data Collection task.
DEVICEMACADDRESS%d. Based on the MAC address count, %d is an integer that references the
actual MAC address environment variable. For example:
IF, DEVICEMACADDRESSCOUNT = 2
Then, DEVICEMACADDRESS0=00:80:5F:7F:B0:81
DEVICEMACADDRESS1=00:80:C7:29:EF:B6
GENERICTRAPID. The SNMP Generic Trap ID of the trap received, if this is an event-based list and
originated from an
SPECIFICTRAPID. The SNMP Specific Trap ID of the trap received, if this is an event-based list and
originated from an SNMP trap.
Path. The Path environment variable value from the context where the service is running
SystemRoot. The SystemRoot environment variable value, from the context where the service is
running.
Windir. The Windir environment variable value, from the context where the service is running.
COMPUTERNAME. The COMPUTERNAME environment variable value, where the context in which
the service is running.
MPIP. The IP address of the associated management processor.
MPNAME. The name of the associated management processor.
RELATEDDEVICECOUNT. The number of associated systems.
RELATEDDEVICENAME%d. The name of the associated system, where %d is the iteration number.
For example:
IF, RELATEDDEVICECOUNT = 2
Then, RELATEDDEVICENAME0=DeviceName0
RELATEDDEVICENAME1=DeviceName1
RELATEDDEVICEIP%d. The IP address of the associated system, where %d is the iteration number.
For example:
General concepts
85