HP Integrity NonStop H-Series User Manual
Page 268

Error Messages
HP AutoSYNC User’s Guide—522580-021
D-10
Critical Event Messages
Effect. The process abends.
Recovery. Since the product usually resizes the segment to satisfy memory requests,
this error should not occur. Report this error to product support.
414
Cause. Allocation of the extended segment failed.
Effect. The process abends.
Recovery. The error number is provided in the message. Determine the reason for the
failure and correct it.
419
Cause. A product component encountered a process trap.
Effect. The process abends.
Recovery. Report the error information to product support.
423
Cause. When an ASYSYNC process starts, it must obtain information from the
AutoSYNC monitor process on the destination system. This error is generated if it was
not possible to contact the monitor.
Effect. The synchronization process terminates. No files are synchronized.
Recovery. Start the AutoSYNC monitor on the destination system.
432
Cause. A source or destination ASYSYNC process detected a version mismatch. The
process that failed and the starting process, either the AutoSYNC monitor or the
source ASYSYNC process if the destination ASYSYNC process failed, have different
versions.
Effect. The ASYSYNC process that detected the version mismatch abends.
Recovery. Install the same AutoSYNC version on the source and destination systems.
Allocate segment error
Utility program process trap
Remote monitor down
ASYSYNC version mismatch