HP Integrity NonStop H-Series - Manual (Page 263)

Error Messages
HP AutoSYNC User’s Guide—522580-021
D-5
Informational Messages
Recovery. A AutoSYNC authorizer with sufficient authority should issue the
AUTHORIZE command as described in the installation procedures. Alternatively,
another user id should be used to configure the SYNCFileset.
115
Cause. The monitor process has attempted to start an ASYSYNC process to perform
AutoSYNC synchronization, but the operation failed.
The message contains PROCESS_CREATE_ error and error detail codes, the userID,
the destination node name and batchid of the failed synchronization.
Effect. AutoSYNC processing for the specified user id is not active.
Recovery. Correct the cause of the failure and the process will be restarted
automatically.
120
Cause. The monitor process has started an ASYSYNC process through TCP/IP to
perform AutoSYNC synchronization. The message contains the process name.
Effect. An ASYSYNC process performs the configured synchronizations.
Recovery. Informational message only; no corrective action is needed.
121
Cause. The monitor process has attempted to start a remote destination ASYSYNC
process through TCP/IP to perform AutoSYNC synchronization, but the operation
failed. The message contains PROCESS_CREATE_ error and error detail code.
Effect. AutoSYNC processing for the specified destination system is not active.
Recovery. Correct the cause of the failure and the process will be restarted
automatically.
122
Cause. A file error occurred while synchronizing a file.
ASYSYNC process failed
ASYSYNC process started via TCP/IP
ASYSYNC TCP/IP remote process creation failure
File Event Occurred