HP Officejet J5740 All-in-One Printer User Manual
Page 188
Solution: Check the display or your computer for an error message providing
information about the problem and how to solve it. If there is an error, the HP All-in-
One will not send or receive a fax until the error condition is resolved.
For more information on error messages, see
Cause: You are using either a PBX or an ISDN converter/terminal adapter.
Solution:
•
Make sure the HP All-in-One is connected to the port that is designated for fax
and phone use. Also, make sure that the terminal adapter is set to the correct
switch type for your country/region, if possible.
NOTE:
Some ISDN systems allow you to configure the ports for specific
phone equipment. For example, you might have assigned one port for
telephone and Group 3 fax and another port for multiple purposes. If you have
problems when connected to the fax/phone port of your ISDN converter, try
using the port designated for multiple purposes; it might be labeled "multi-
combi" or something similar.
•
Try setting the Fax Speed to Medium or Slow.
Cause: The Fax Speed setting is set too fast.
Solution: You might need to send and receive faxes at a slower rate. Try setting
the Fax Speed to Medium or Slow if you use one of the following:
•
An Internet phone service
•
A PBX system
•
Fax over Internet Protocol (FoIP)
•
An ISDN service
To set the fax speed from the control panel
1.
Press Setup.
2.
Press 5, and then press 7.
This selects Advanced Fax Setup and then selects Fax Speed.
3.
Press to select one of the following settings, and then press OK.
Fax speed setting
Fax speed
Fast
v.34 (33600 baud)
Medium
v.17 (14400 baud)
Slow
v.29 (9600 baud)
Cause: The HP All-in-One might be connected to a telephone wall jack that is set
up for digital phones.
Solution: Make sure you connect the HP All-in-One to an analog phone line or you
will not be able to send or receive faxes. To check if your phone line is digital, connect
a regular analog phone to the line and listen for a dial tone. If you do not hear a normal
Chapter 11
186
Troubleshooting