Start the tape library and tape drive, Verify the tape configuration – HP NonStop G-Series User Manual
Page 130
Configuring the CTL700 Tape Library for the
NonStop BladeSystem Server
L700 (CTL700) Installation and User’s Guide — 527338-008
C- 2
Start the Tape Library and Tape Drive
Start the Tape Library and Tape Drive
After the tape library is added, use the START command to start it:
->
START SCSI $CTL700
After the tape drive is added, use the START command to start it:
->
START TAPE $M8608A
Verify the Tape Configuration
To check that the tape drive was successfully added, issue the SCF STATUS tape-
name, detail command:
->
STATUS TAPE $M8608A, DETAIL
STORAGE - DETAILED STATUS TAPE \OSMQA5.$M8608A
Tape Process Information:
Tape I/O Process Information:
Library File.......
Program File....... $SYSTEM.SYS00.OTPPROCP
Current Settings:
LDev
State
Primary PID
Backup PID
DeviceStatus
197
STARTED
0,322
1,351
ONLINE, BOT
ACL................ NOT INSTALLED
Buffer Level...... RECORD
Checksum Mode...... NORMAL I/O
*Compression....... ON
*Density............ 38000
Media Type........ Not applicable
Opens.............. 0
*RecSize........... 2048
Short Write Mode... ALLOWED, PADDED
SubType........... 16
Volume Switching... TRANSPARENT