HP NonStop G-Series - Manual (Page 125)

Configuring the CTL700 Tape Library for the
NonStop NS-Series Server
L700 (CTL700) Installation and User’s Guide — 527338-008
A -11
Adding the Control Path
Adding the Control Path
To add the control path:
In SCF, issue this command:
SCF> ADD SCSI $device, SENDTO STORAGE, PRIMARYLOCATION
(group, module, slot), PRIMARYSAC sac-id, LUN lun-id,
PRIMARYPORT 64-bit-portname
Example:
SCF> ADD SCSI $CTL700, SENDTO STORAGE, PRIMARYLOCATION
(110,2,2), PRIMARYSAC 2, LUN 0, PRIMARYPORT 1234567891234567
For complete details about the ADD and STATUS commands, including command
syntax, see the SCF Reference Manual for the Storage Subsystem.
Note. To obtain the portname number for your control path, contact a service representative
from STK. The portname number that is used in this section is used only for an example.