HP ProLiant ML350 G4 Server - Manual (Page 92)

92 HP ProLiant ML350 Generation 4p Server User Guide
Connecting ATA or ATAPI Devices to the Integrated
IDE Controller
This server includes one IDE cable (the Cable Select Cable) that can connect up
to two ATA or ATAPI devices to the system through the integrated IDE
controller. This cable has three clearly labeled connectors. If only one IDE
device is connected to the system, it must be secured to the cable connector
labeled Drive 0. All IDE devices in the system should have their configuration
jumpers set to "Cable Select" or "CS."
IMPORTANT: If the network operating system is Novell NetWare, HP
recommends that you connect the CD-ROM to the primary IDE channel
and to the Drive 0 connector on the IDE cable.
NOTE: ATA (IDE) hard drives are not supported.