HP ProLiant ML350 G4 Server - Manual (Page 44)

44 HP ProLiant ML350 Generation 4p Server User Guide
To configure these utilities manually:
•
•
Press the F8 key when prompted during the array controller initialization to
configure the array controller using ORCA.
Press the F9 key when prompted during the boot process to change the server
settings using RBSU. The system is set up by default for the English
language.
For more information on the automatic configuration, refer to the HP ROM-
Based Setup Utility User Guide located on the Documentation CD.
Installing the Operating System
To operate properly, the server must have a supported operating system. For the
latest information on supported operating systems, refer to the HP website
(
http://www.hp.com/go/supportos ).
Two methods are available to install an operating system on the server:
•
•
SmartStart assisted installation—Insert the SmartStart CD into the CD-ROM
drive and reboot the server.
Manual installation—Insert the operating system CD into the CD-ROM drive
and reboot the server. This process may require you to obtain additional
drivers from the HP website (
http://www.hp.com/support ).
Follow the on-screen instructions to begin the installation process.
For information on using these installation paths, refer to the SmartStart
installation poster in the HP ProLiant Essentials Foundation Pack, included with
the server.
Registering the Server
To register a server, refer to the registration card in the HP ProLiant Essentials
Foundation Pack or the HP Registration website (
http://register.hp.com ).