HP Virtual Connect Enterprise Manager Software - Manual (Page 93)

Table 43 VCEM server error messages and descriptions (continued)
Error message description
NOTE: The error message descriptions in this table use
[x] to represent variables in the error message output. Error message number
Cannot perform server profile unassignment because the
specified server profile is not currently assigned to a server
bay. 2619
Cannot perform the {0} operation because the VC Domain
maintenance is not completed. Perform these steps: 2620
1. Go to the VCEM - VC Domains tab and select the VC
Domain that is under maintenance.
2. Click VC Domain Maintenance.
3. Click Complete VC Domain Maintenance to apply the
configuration changes to the entire VC domain group,
or click Cancel to not apply changes and restore the
current VC domain group configuration to the VC
Domain. Verify that the VC Domain maintenance
operation was completed or canceled with success, and
then perform the operation again.
Cannot perform rollback on a server profile move operation
because the server profile could not be assigned back to
its original Server Bay. The profile is saved as unassigned. 2623
Cannot move the server profile because the specified server
profile is not currently assigned to a Server Bay. 2624
The number of FC SAN connections is incorrect. 2625
In the FC SAN connection for interconnect bay , the range
type is not compatible with the addresses inside the
connection. 2626
A server profile cannot have less than two Ethernet network
connections. At least two Ethernet network connection
physical ports are required. 2627
In the FC SAN connection for interconnect bay , the
connection was replaced by a new one. To replace a 2628
connection by a new one, first edit the profile and delete
the connection, then edit the server profile again and add
a new connection.
It was not possible to remove the provided vNet mapping
from the server profile. 2629
The target server bay does not support server profiles.
Verify the device in the server bay is supported by VC
Manager. 2630
Server Profile identifier cannot be found. Verify that a server
profile is informed, the associated VC Domain is managed
by VCEM and the server profile exists in VCEM. 2631
Specified Server Bay ID does not correspond to a managed
server profile in VCEM. 2632
Cannot perform server profile move because the specified
server profile was already moved from Server Bay on VC
Domain . 2633
Cannot perform the server profile operation because it is
not possible to have connections with different address
types in the same server profile. 2636
93