HP Virtual Connect Enterprise Manager Software - Manual (Page 66)

remove server-port-map
The –remove server-port-map command removes a server port network mapping.
NOTE: The –remove server-port-map command cannot be used if the domain setting
vlantagcontrol is set to tunnel. This restriction is lifted for VC domain groups running VC
3.30 and later firmware mode.
Syntax
-remove server-port-map –profilename
-portnumber
[-network ]
Parameters
Table 26 Parameter descriptions for –remove iscsi-boot-param
Optional Required Description Parameter
x Specifies the name of the
profile from which the server -profilename
port mapping is to be
removed.
x Specifies the port number of
the server port mapping
targeted for removal. -portnumber
x Specifies the name of an
Ethernet network on which
the mapping exists. -network
Output
The function returns the result of the remove operation or a jobid if –nb is specified.
Examples
•
Remove a server port network mapping that has the name Rednetwork:
vcemcli -remove server-port-map –profilename MyProfile –portnumber
1 –network RedNetwork
•
Remove all the server port network mappings from an Ethernet connection:
vcemcli -remove server-port-map –profilename MyProfile –portnumber
1
Minimum required role-based security
VCEM Group Operator
Remarks
You can obtain the job status for the jobid by executing the VCEMCLI with the –show job
command and providing the associated job ID. For more information, see
“show job” (page 74) .
66 Using VCEM commands