HP Virtual Connect Enterprise Manager Software - Manual (Page 91)

Table 43 VCEM server error messages and descriptions (continued)
Error message description
NOTE: The error message descriptions in this table use
[x] to represent variables in the error message output. Error message number
Server profile name is duplicate. Another server profile
with the same name already exists in VCEM. 2552
There are more than one network interfaces (NIC)
configured with PXE enabled. Only one NIC in the profile
can be PXE enabled. 2553
Cannot remove network connection. Verify: 1- The provided
connection exists. 2- The provided port number is different 2554
from 1 or 2. 3- The provided connection is the last one in
the network connections list.
Cannot find network connection for the specified port
because the port number is invalid. Verify there is a
connection for the provided port number. 2555
Cannot create network connection because the specified
network does not exist. Enter a valid network name. 2556
In the FC SAN connection for interconnect bay , the
selected FC SAN fabric does not exist. The provided FC 2557
SAN fabric must exist in the VC Domain group the Server
profile belongs.
Cannot create a network connection for the entered port.
Ethernet network connections require a valid network. Verify 2559
all port connections are correctly pointing to a valid
network and then perform the operation again.
In the FC SAN connection for interconnect bay , the
selected FC SAN fabric does not have a physical
connection to this port. 2560
The server bay cannot be changed when updating an
assigned server profile. 2561
The entered MAC addresses is invalid. Verify it is well
formed (NN-NN-NN-NN-NN-NN, where N is a
hexadecimal digit (0-F)). 2562
The entered WWN addresses is invalid. Verify it is well
formed (NN:NN:NN:NN:NN:NN:NN:NN, 2563
NN-NN-NN-NN-NN-NN-NN-NN or
NNNNNNNNNNNNNNNN, where N is a hexadecimal
digit (0-F)).
The entered Logical Serial Number is invalid. Verify it is
well formed (VCX00NNNNN, VCX01NNNNN or 2564
VCYNNNNNNN, where N is a alpha-numeric digit (0-9
or A-Z)).
Cannot configure FC SAN connection because the specified
the interconnect bay number is invalid. 2601
Cannot configure FC SAN connection because the specified
FC SAN fabric does not exist or it cannot be assigned to 2602
the provided port. Each FC SAN fabric can only be
assigned to its corresponding port. Verify the provided FC
SAN fabric exists and can be assigned to the provided
port.
In the FC SAN connection for interconnect bay , the
selected port speed is invalid. 2603
91