HP Integrity Essentials Pack for Linux Software - Manual (Page 23)

5. Change directories to \EFI\boot, and then enter the following:
# BootIA64.efi
The Smart Setup EBSU entry is created in the EFI Boot Manager as a selection for booting
to launch the HP Smart Setup EBSU utility.
Enabling a USB Device
To access a USB HDD device, you must enable the EFI shell to detect and then access it using
the following steps:
IMPORTANT: The USB HDD device must be formatted with a FAT32 file system.
1. From any Linux system, go to the http://www.hp.com/go/integritylinuxessentials website,
and click on the Download for HP Insight Foundation Suite for Integrity with Linux link.
2. Click the link for the HP Smart Setup tar file to download the file to a local folder.
3. Connect the USB HDD device, and then mount it if the OS does not do so automatically.
4. Extract the contents of the HP Smart Setup tar file to the USB HDD device, making sure that
the EFI folder structure is in the root directory.
# tar zxvf ebsu-version.tgz –C /mnt/usb
5. Unmount the USB device:
# umount /mnt/usb
CAUTION: Failure to unmount the USB device will result in data loss.
6. Connect the USB device to the intended server.
7. From the EFI shell, enter the following:
Shell> reconnect -r
The reconnect command reconnects one or more drivers from a device, disconnecting all
the drivers from all the devices and then reconnecting them. If a device handle is not specified,
the reconnect operation is performed on all the handles in the system. If a device handle is
specified, only the device handle and the devices below it are reconnected.
8. Regenerate all mappings:
Shell> map -r
The -r option regenerates all the mappings in a system. The EFI shell displays a device
mapping table.
TIP: The map command displays or defines a mapping between a user-defined name and
a device handle. The most common use of this command is to assign drive letters to device
handles that support a file system protocol. After these mappings are created, the drive
letters can be used with all the file manipulation commands. It can also be used to create
new mappings and delete existing mappings using the -d option. If the map command is
used without any options, all the current mappings are listed. If the -v option is used, the
mappings are shown with additional information on each mapped handle.
9. Record the device name of the USB HDD device, fs0, for example. Use this device name to
explore the contents of the removable media.
10. Go to the USB file system:
# fsnumber:
Preparing the Server Hardware 23