Select smart setup – HP Integrity Essentials Pack for Linux Software User Manual
Page 29
NOTE:
If you have just configured a RAID volume, then you must reboot the system so
that it is detected. Additionally, on rx7620 and rx8620 servers, you must run the search
all
command from the EFI shell before attempting to use this volume.
10. To launch the Smart Setup wizard, from the Main Menu select Smart Setup and press Enter,
as shown in
.
Figure 3-8 Select Smart Setup
11. Smart Setup provides an introduction to the wizard.
NOTE:
To install Linux on a RAID volume or a Fibre Channel LUN, you must first ensure
that this storage is configured as described in the previous steps.
Select Next and press Enter to continue and display the next screen.
Smart Setup Page 1 (
) is the firmware update screen, which lists each system
device, its installed firmware version, and the firmware version that is in the HP Insight
Foundation Suite for Integrity with Linux you are using.
Figure 3-9 Page 1: Update Firmware
If the server is cell-based, the firmware update screen is slightly different as shown in
Using HP Smart Setup to Install the OS
29