Backing up existing data, Setting up a console, Setting up a serial console – HP Integrity Essentials Pack for Linux Software User Manual
Page 20
5.
Verify existing device compatibility at the HP Integrity server connectivity website:
6.
Verify storage compatibility by reviewing the HP Integrity Server-Storage Support Matrices
located at:
NOTE:
This list is not exhaustive because storage vendors may support more configurations
than those indicated at this site. As a general rule, check with your storage vendor and an
HP Sales Representative for a definitive statement on server-storage compatibility.
Backing Up Existing Data
To restore the data from the hard disk on your server after migrating to Linux, you must first
back up the data and verify that it can be restored. Use the following guidelines:
1.
Perform a server-wide backup using your existing backup utilities.
2.
Verify the integrity of the backup by restoring samples of data to another server.
3.
Store the backup in a safe place.
Setting Up a Console
You can install the OS and administer the server from either a VGA console, a serial console, or
both.
On HP Integrity rx1600, rx1620, rx2600, and rx2620 servers, the Management Processor (MP) is
optional. In cases where the MP was not ordered, the only console is the serial interface on the
bulkhead connector. This connector is a serial port (UART) and must be configured for use. For
configuration information, see
“Configuring and Using a Serial Console” (page 51)
.
Setting Up a Serial Console
From the serial console, you can access the EFI shell and the MP. Use these utilities while installing
and administering Linux on HP Integrity servers.
You can configure a serial console in two ways:
•
Connect a PC to the MP serial port using a null modem cable.
•
Connect a PC to the MP LAN port using a cat5 LAN cable.
On a system running Linux, the SSH client is the native terminal emulator application.
On a system running Windows, use a terminal emulator application, such as PuTTY or
HyperTerminal. PuTTY is a free implementation of Telnet and SSH for 32-bit Linux and UNIX,
and it provides an xterm terminal emulator. HP recommends that you use PuTTY version 0.57
or later, which is available the HP Insight Foundation Suite for Integrity with Linux or from the
PuTTY Download Page website:
To set up a serial console, perform the following steps:
1.
Use a null modem cable to connect a PC to the MP serial port or to the serial console port
(for systems without MP), or use a cat5 cable to connect a PC to the MP LAN port.
2.
If necessary, install a terminal emulator and specify the following port settings:
— Bits per second: 9600
— Data bits: 8
— Parity: none
— Stop bits: 1
— Flow Control: Xon/Xoff
20
Preparing for Installation