Enww interpret control-panel messages 193 – HP Color LaserJet Enterprise CP4525 Printer series User Manual
Page 207
Description
Recommended action
INCOMPATIBLE FUSER
The incorrect fuser was installed.
CAUTION:
The fuser can be hot while the
product is in use. Wait for the fuser to cool
before handling it.
1.
Open the right door.
2.
Remove the incompatible fuser.
3.
Install the correct fuser.
4.
Close the right door.
INCOMPATIBLE SUPPLIES
For status press OK
Print cartridges or other supply items are
installed that were not designed for this
product. The product cannot print with these
supplies installed.
Press the
OK
button to identify the
incompatible supplies. Install supplies that
are designed for this product.
INCOMPATIBLE TRANSFER UNIT
The incorrect transfer unit was installed.
1.
Open right door.
2.
Remove the incompatible transfer unit.
3.
Install the correct transfer unit.
4.
Close the right door.
Incorrect
The PIN is incorrect.
Use the up arrow and down arrow
buttons to enter the correct PIN.
Initializing
The product is starting.
No action is necessary. Please wait until the
Ready message appears on the display.
Initializing permanent storage
Displayed when the product is turned on to
show that permanent storage is being
initialized.
No action is necessary.
INSTALL
The print cartridge has been removed or has
been installed incorrectly.
Replace or reinstall the print cartridge
correctly to continue printing. See
.
INSTALL FUSER
The fuser has been removed or installed
incorrectly.
CAUTION:
The fuser can be hot while the
product is in use. Wait for the fuser to cool
before handling it.
1.
Open the right door.
2.
Install or adjust the fuser.
3.
Close the right door.
INSTALL SUPPLIES
For status press OK
More than one supply is missing or is installed
incorrectly.
Press the
OK
button to identify which supplies
need to be replaced. Press the
OK
button a
second time for more information about the
specific supply. Insert the supply item or
make sure the installed supply item is fully
seated.
INSTALL TRANSFER UNIT
The transfer unit has been removed or
installed incorrectly.
1.
Open right door.
2.
Install the transfer unit.
3.
Close the right door.
INSUFFICIENT MEMORY TO LOAD
FONTSDATA
The product does not have enough memory
to load the data (for example, fonts or
macros) from the location specified.
To continue without this information, press
the
OK
button . If the message persists, add
more memory.
Table 10-1
Control-panel messages (continued)
ENWW
Interpret control-panel messages 193