HP Integrity NonStop H-Series - Manual (Page 67)

Changing Telnet and FTP settings
To change Telnet and FTP settings, perform the following steps from the NonStop Development
perspective:
1. Open the Network Connections preference page ( Figure 20 (page 65) ) by selecting NonStop
Tools > Configure Connections...
2. Use the System: combo box to select a connection configuration whose Telnet/FTP settings
you will change.
3. Open the Telnet/FTP Settings dialog ( Figure 23 (page 67) ) by selecting the Settings... button
to the right of the Telnet/FTP button.
Figure 23 Telnet/FTP Settings dialog
4. Table 4 (page 67) describes the settings you can change in the Telnet/FTP Settings dialog.
Table 4 Telnet/FTP settings
Description Setting
Enter port NSDEE will use to connect to the Telnet server on the
NonStop system. (Default is 23.) Telnet port: field
Enter port NSDEE will use to connect to FTP server on the
NonStop system. (Default is 21.) FTP port: field
Select to have NSDEE use active protocol when opening FTP
ports. Active FTP button
Select to have NSDEE use passive protocol when opening FTP
ports. Passive FTP button
Select to have NSDEE save password in encrypted form after
first successful login. NSDEE will use saved password on
subsequent logins. Save password (encrypted) button
Select when directly connecting to a STATIC window based on
the IPv4 or IPv6 address of the client. Default (no service or window choice) button
Configuring connections to NonStop 67