HP Integrity NonStop H-Series - Manual (Page 123)

Table 5 NonStop views (continued)
Description Provider View
makefile.targets file for managed builds” (page 110) ), you can add that
target to the Make Target view as a named build icon. Then you can
initiate a build of that target by double-clicking the named build icon in
the Make Target view.
CDT provides additional views for showing call hierarchies, type hierarchies, and more. To see
all views available to you, select Window
→Show View→Other... to open the Show View dialog.
Figure 85 (page 123) shows the Show View dialog with C/C++-specific views visible.
Figure 85 Show View dialog with C/C++ specific views
Many of the views shown in the NonStop Development perspective are available in the General
folder shown in the above figure, whereas the Make Target view is available in the Make folder
shown above.
NOTE: You can restore the NonStop Development perspective's default views and default view
locations by selecting Window
→Reset Perspective....
Figure 86 (page 124) shows the one view specific to NonStop available from the Show View dialog.
Views and editors 123