HP XP7 Storage - Manual (Page 71)

Value (severity) Explanation
6 Error-level, Warning-level, and Information-level
audit log data is collected.
7
The table below lists and describes the values for the audit log category
setting.. The default is all.
Table 3-6 Values Indicating Audit Log Data Categories
Value Explanation
ss Audit log events of the StartStop category are collected.
a Audit log events of the Authentication category are collected.
ca Audit log events of the ConfigurationAccess category are collected.
all Audit log events of the StartStop, Authentication, and
ConfigurationAccess categories are all collected.
This example shows how to enable the collection of audit log data:
dlnkmgr -l set -audlog on -audlv 6 -category all
Specify on if you want to collect audit log data, and off if you do not want to
collect audit log data. If you specify on, you can use the -audlv parameter to
specify the collection level for audit log data and the -category parameter to
specify the audit log categories.
Checking the Updated Settings
This chapter describes steps involved in how to check the new settings by
using the dlnkmgr command's set operation after the new settings are
applied.
When you some these settings, you can display information about all of HDLM
function settings. The following is an example of executing the command:
PROMPT>dlnkmgr -s host-name -u user-name -p password view -sys -sfunc
HDLM Version : x.x.x-xx
Service Pack Version :
Load Balance : on(extended lio)
Intermittent Error Monitor : on(2/20)
Dynamic I/O Path Control : off(10)
KAPL01001-I The HDLM command completed normally. Operation name =
view, completion time = yyyy/mm/dd hh:mm:ss
PROMPT>
After you have set up the collection of audit log data, use the following
command to make sure that the setting has been specified correctly:
PROMPT>dlnkmgr -l view -sys -audlog
Creating an HDLM Environment
3-19
Hitachi Dynamic Link Manager (for VMware®) User Guide