Storage systems supported by hdlm, Memory and disk capacity requirements, Storage systems supported by hdlm -3 – HP XP7 Storage User Manual
Page 55: Memory and disk capacity requirements -3, Memory requirements -3
A remote management client can run on a machine in the same LAN as the
host, or on a guest OS installed on the host itself.
VMware vSphere CLI 5.0/5.1/5.5 is a prerequisite program for a remote
management client. Make sure that VMware vSphere CLI is installed before
installing HDLM.
Storage Systems Supported by HDLM
HDLM supports the following storage systems:
If an FC-SAN is used:
•
Hitachi AMS2000/AMS/WMS/SMS series
•
Hitachi Universal Storage Platform V
•
Hitachi Universal Storage Platform VM
•
Hitachi Virtual Storage Platform
•
Hitachi Virtual Storage Platform G1000
•
HUS100 series
•
HUS VM
•
HP StorageWorks P9500 Disk Array
•
HP XP7 Storage
•
XP20000/XP24000
If an IP-SAN is used:
•
Hitachi AMS2000/AMS/WMS/SMS series
The supported storage systems require a dual controller configuration. If you
use the system in a HUB environment, you must set a unique loop ID for
every connected host and storage system. For details about the micro-
program versions for using HDLM, see the HDLM Release Notes. For details
about storage system settings required for using HDLM, see the maintenance
documentation for storage systems.
Memory and Disk Capacity Requirements
This section describes memory and disk capacity requirements.
Memory Requirements
The memory requirements for a host and remote management client are as
follows:
•
Host
10 MB
•
Remote management client
40 MB
Creating an HDLM Environment
3-3
Hitachi Dynamic Link Manager (for VMware®) User Guide