HP Compaq t5710 Thin Client - Manual (Page 99)

6-39
Setup Menus
Selecting End on Non-Hex enables you to specify the number of characters that make
up the end sequence in the End Length box. The bypass will then terminate as soon as
a non-hexadecimal character is received (any character except in the range 0 through 9
and A through F) followed by the end sequence.
Characters can be entered in several ways. For example, to specify the ASCII escape
character, you can enter either _027, \u001B, \e, \033, or even ^[.
Font
This enables you to specify the font to be used for displaying characters. The available
settings depend on the fonts installed.
SBCS, APL2 & DBCS
The Single Byte Character Set, APL2 and Double Byte Character Set options enable
you to change the settings used by default for the chosen language. These should only
be changed by the System Administrator. If they have been changed and you wish to
restore the default settings in this dialog box, click the Default button. The following
table shows the default settings. A list of IBM EBCDIC codepages supplied can be
found at the end of the Character Sets appendix.
Note: Double byte character sets may not be supported by this
version of the emulator.