HP Compaq t5710 Thin Client - Manual (Page 84)

6-24
Setup Menus
FldSeparator
Factory default: ^_ (i.e. US)
This text box is used to specify the ASCII character used to indicate the end of each
protected field (except the last) that is sent in Edit Mode.
To change the current definition, delete the definition displayed in the text box and
type in the new one, either as the control key character equivalent or the decimal value
of the ASCII character. For example, the default ASCII character US can be entered by
typing the characters ^ and _, representing the keys Ctrl + _ which, when pressed
together would generate the US code.
Decimal values are entered as three-digit numbers immediately preceded by an
underscore character. Values with only two digits must be preceded by a zero. For
example, the decimal value of US is 31, so this would be entered as _031. Refer to the
ASCII character table in the Character Sets appendix for code and decimal references.
BlkTerminator
Factory default: ^^ (i.e. RS)
This text box is used to specify the ASCII character sent to the host to indicate the end
of a data block transmission.
To change the current definition, delete the definition displayed in the text box and
type in the new one, either as the control key character equivalent or the decimal value
of the ASCII character. For example, the default ASCII character RS can be entered by
typing the character ^ twice, representing the keys Ctrl + ^ which, when pressed
together would generate the RS code.
Decimal values are entered as three-digit numbers immediately preceded by an
underscore character. Values with only two digits must be preceded by a zero. For
example, the decimal value of RS is 30, so this would be entered as _030. Refer to the
ASCII character table in the Character Sets appendix for code and decimal references.
Terminal ID
Factory default: 70092
This specifies what is reported back to the host in response to a terminal identification
request. (Note that not all features of the specified terminal may be supported.)
Clicking the arrow button will display a drop-down list box showing the available
settings, 70092, 2392A, 2622A, 70094 or 70096. If you are using the keyboard, press
the up or down arrow keys until the setting required is displayed. You can either select
from this list or enter a different terminal identity in the text box.