HP Compaq t5710 Thin Client - Manual (Page 22)

2-10
Getting Started
TCP/IP Connection Settings
The TCP/IP Telnet Configuration dialog box can be displayed from the Connection
Wizard Host Information dialog box by setting the Connection Type to TCP/IP
then clicking the Advanced button, or the New Connection dialog box when in non-
WBT mode by selecting TCP/IP in the Type list box then clicking the Configure
button.
Note that the options available and the default settings depend on the current terminal
emulation.
Host Port Number
This enables you to specify the Telnet port number. The default Telnet port number,
23, can be substituted with any valid 16 bit port number. Specifying a number outside
the valid range will cause the setting to default to 1.
Local Port Number
This enables you to specify the local Telnet port number if required. Setting this to 0
will cause the number to be allocated automatically.
Telnet Name
This enables you to override the name that will be reported for the terminal type over
Telnet.
Enable Keep Alives
Selecting this option will prevent the session from being disconnected from the host by
an inactivity timeout.