HP Compaq t5710 Thin Client - Manual (Page 93)

6-33
Setup Menus
Auto Page
Factory default: Unselected
This option applies to the WY-50+, WY-60 and all the TVI emulations. It determines
what happens when the cursor reaches the top or bottom of the page.
When unselected, the cursor either moves to the top of the same page or data scrolls up
from the bottom, as determined by the setting of the Auto Scroll option. When
selected, a new page of memory will be displayed.
Note: The other emulations will always display a new page of
memory.
Auto Wrap
Factory default: Selected
The setting of this option determines whether characters wrap to the next line when the
right margin is reached. When unselected, on reaching the right margin, the last
character position will be overwritten by every new character received.
DEL = DestBS
Factory default: Unselected
This option applies to the WY-50+ and WY-60 emulations and determines what effect
an ASCII DEL character has on displayed characters. The other emulations ignore the
DEL character.
When unselected, the DEL character is ignored. When selected, the DEL character is
interpreted as a destructive backspace, causing the character to the left of the cursor to
be deleted and the cursor to move into that position.
Margin Bell
Factory default: Unselected
This option applies to all emulations and specifies whether or not an audible warning
sounds when the cursor reaches a specified column. The default bell column number is
72 in 80 column mode and 124 in 132 column mode.
Enhance
Factory default: Selected
When this option is selected, the emulator will recognize an additional set of Wyse
codes which are not normally supported by specific non-Wyse terminals.
Answerback Mode
Factory default: Unselected
This option applies to all emulations and specifies whether or not an answerback
message is automatically sent to the host in response to an ASCII ENQ character.