HP Compaq t5710 Thin Client - Manual (Page 273)

C-1
Host Command Summary
C
Host Command Summary
This appendix lists the host commands that are valid in each terminal
emulation mode. Additional special commands are listed at the back.
The following conventions are used in this command list. Spaces in a command are for
clarity only and are not to be entered as part of the command. A space character that is
part of the command will be shown as SP. An asterisk (*) in a command indicates the
location of one or more parameters except otherwise indicated next to the command.
Note that IBM 3270 and IBM 5250 emulation commands are not included because of
their complexity. Refer to the manuals supplied with these terminals for the host
commands that are supported.
VT52 Emulation
CHARACTER SET SELECTION
Invoke G0 character set SI
Invoke G1 character set SO
Select G0 character set ESC G
Select Line Drawing character set ESC F
CURSOR
Direct cursor addressing (1 to 96 = SP to DEL) ESC Y *line *column
Insert FF character & advance cursor FF
Line feed LF
Move cursor down one line ESC B
Move cursor down one line VT
Move cursor home ESC H
Move cursor one column left BS
Move cursor one column left ESC D
Move cursor one column right ESC C
Move cursor to left margin of current line CR
Move cursor to next tab stop HT
Move cursor up one line ESC A
Reverse line feed ESC I