HP LaserJet M9040M9050 Multifunction Printer series - Manual (Page 43)

Menu item Sub-menu item Sub-menu item Values and Description
A Talk Enable Off : Disable the AppleTalk protocol.
On (default): Enable the AppleTalk protocol.
DLC/LLC Enable Off : Disable the DLC/LLC protocol.
On (default): Enable the DLC/LLC protocol.
Security Print Sec Page Yes : Prints a page that contains the current security
settings on the HP Jetdirect print server.
No (default): A security settings page is not printed.
Secure Web For configuration management, specify whether the
embedded Web server will accept communications
using HTTPS (Secure HTTP) only, or both HTTP and
HTTPS.
HTTPS Required (Default) : For secure, encrypted
communications, only HTTPS access is accepted. The
print server will appear as a secure site.
HTTP/HTTPS optional : Access using either HTTP or
HTTPS is permitted.
IPsec or Firewall Specify the IPsec or Firewall status on the print server.
Keep : IPsec/Firewall status remains the same as
currently configured.
Disable (Default): IPsec/Firewall operation on the print
server is disabled.
Reset Security Specify whether the current security settings on the
print server will be saved or reset to factory defaults.
No (default): The current security settings are
maintained.
Yes : Security settings are reset to factory defaults.
Diagnostics Embedded Test This menu provides tests to help diagnose network
hardware or TCP/IP network connection problems.
Embedded tests help to identify whether a network fault
is internal or external to the device. Use an embedded
test to check hardware and communication paths on
the print server. After you select and enable a test and
set the execution time, you must select
Execute to
initiate the test.
Depending on the execution time, a selected test runs
continuously until either the device is turned off, or an
error occurs and a diagnostic page is printed.
LAN HW Test CAUTION: Running this embedded test will erase
your TCP/IP configuration.
This test performs an internal loopback test. An internal
loopback test will send and receive packets only on the
internal network hardware. There are no external
transmissions on your network.
Table 2-10 Jetdirect menus (continued)
ENWW Use the Administration menu 29