HP ProLiant SL165z G7 Server - Manual (Page 56)

Using LO100 56
After you issue the load command to upload and install the certificate, reset the BMC by entering the
following command:
reset map 1
LO100 checks the validity of the key/certificate pair after you reset the BMC.
You can also find these commands in /map1/firmware directory.
To successfully establish SSH/SSL connections after loading a key or certificate through the CLI or the
GUI, and after you click Apply, you must reset the BMC by choosing either of the following:
• Issuing the following command from the CLI (/./-> cd map1 a"reset map 1")
• Physically pulling AUX power
HP Systems Insight Manager support
HP Systems Insight Manager discovers LO100 to identify and launch LO100 and its license manager to
retrieve or deploy LO100. See your HP Systems Insight Manager user guide for more information on
using HP Systems Insight Manager with LO100.
Resolving character and line feed issues
HP recommends using similar operating systems to communicate between the CMS and your applications
or workstations. For example, if you are running a Linux CMS, run Linux on your workstations, and use a
Linux telnet client. Likewise, if you are running a Windows® CMS, run Windows on your workstations,
and use a Windows® Telnet client.
If you run multiple operating systems in your environment, an application limitation issue might occur. For
example, running Linux on your servers and using a Windows® Telnet client or PuTTY might cause an end
of line character issue. If you experience issues, do one the following:
• For a Windows® Telnet client to Linux console redirection configuration, make sure Windows®
Telnet sends a CR for the line feed. To set CR, use the following command for Windows® Telnet:
unset crlf
• For applications such as PuTTY with Linux redirection:
a. Click Connection>Telnet.