HP NonStop G-Series - Manual (Page 86)

Maintenance for the 5257ACL
5257/5257ACL Installation and User's Guide for NonStop Himalaya S-Series Tape Enclosures — 522344-001
8 -2
When to Run
5. Insert the magazine into the 5257ACL.
6. Close the magazine door.
When to Run
If you enable the Autoclean Mode on the Configuration menu, the ACL runs the
cleaning cartridge automatically whenever the Use Cleaner LED comes on.
Running From the Front Panel
This procedure requires that the cleaning cartridge be installed into Slot 1 of the
magazine and that no reserved slots are set.
1. At the Default screen, press Enter. The screen in Figure 8-1 appears.
Figure 8-1. Main Menu
2. Scroll down to move the next to Maintenance menu, then press Enter to select the
Maintenance menu. The screen in Figure 8-2 appears.
Figure 8-2. Maintenance Submenu
3. Press Enter once to select Clean Drive. The screen in Figure 8-3 appears.
Figure 8-3. Maintenance Submenu
Note. The cleaning cartridge is abrasive, and should not be used unless the Use Cleaner LED
comes on.
L o a d / U n l o a d
U n l o c k D o o r
S h ow S tatus M enu
M ain ten ance M enu
C le a n D rive
D ia g n o s tic M e n u
D e m o M e n u
F l a s h U p d a t e
Clean ing:
* SDL T1
Using
*Slot 1