HP NonStop G-Series - Manual (Page 31)

5257/5257ACL Installation and User's Guide for NonStop Himalaya S-Series Tape Enclosures — 522344-001
3 -1
3
Installing the 5257 Tape Drive
This section includes these topics:
Connecting the Power Cord
1. Check that the tape drive power switch is set to 0 (OFF).
2. Connect the power cord to the tape drive power connector, and check that the
connector is fully seated. See Figure 3-1 .
Topic Page
Connecting the Power Cord 3-1
Connecting the SCSI Cables 3-2
Powering on the Tape Drive 3-3
Power-On Self-Test 3-3
5257 Troubleshooting Chart 3-4
Figure 3-1. Attaching the Power Cord
WARNING. Do not attach the male end of the power cord to the power outlet at this time.