Remote access to the virtual connect manager – HP Integrity BL870c i2 Server-Blade User Manual
Page 11
Introduction 11
login as: michael
password: ***********
--------------------------------------------------------------------
HP Virtual Connect Management CLI v3.00
(C) Copyright 2006-2007 Hewlett-Packard Development Company, L.P.
All Rights Reserved
--------------------------------------------------------------------
GETTING STARTED:
help : displays a list of available subcommands
exit : quits the command shell
->
Non-Interactive Mode
In some cases, users might want to write automated scripts that execute a single command at a time.
These scripts can be used to batch several commands in a single script file from the SSH client. An
example of how to use the non-interactive mode for CLI command execution is provided below. In the
example, the primary VCM is located at IP address 192.168.0.120.
IMPORTANT:
To suppress prompting for a password during login, you must first setup the
SSH encryption keys using the VCM Web GUI, and configure your SSH client properly with
the keys. For additional information on configuring the SSH keys, see the HP Virtual Connect
for c-Class BladeSystem User Guide.
->ssh [email protected] show enclosure
Remote access to the Virtual Connect Manager
The Virtual Connect Manager CLI can be accessed remotely through any SSH session:
1.
Start an SSH session to the Virtual Connect Manager using any SSH client application.
2.
When prompted, type the assigned IP address or DNS name of the Virtual Connect Manager, and
then press Enter.
3.
Type a valid user name, and then press Enter.
4.
Type a valid password, and then press Enter. The CLI command prompt displays.
5.
Enter commands for the Virtual Connect Manager.
6.
To terminate the remote access SSH session, close the communication software or enter exit at the
CLI command prompt.