HP xw4400 Workstation - Manual (Page 90)

HP Remote Graphics 4.2.0 User's Guide
82
Rgsender.IsDisconnectOnLogoutEnabled=bool
If set to "1", the RGS connection will be disconnected when the user logs out. If set
to "0", the RGS connection will remain connected to the sender when the user logs
out. The default value is 1 - always disconnect when the user logs out.
Rgsender.IsSnapToCodecEnabled=bool
If set to "1", the HP Codec will be aligned or snapped to tile boundaries. This will
avoid persistent visual artifacts at the expense of potentially increased bandwidth
usage. If set to "0", the alignment of the codec with respect to the screen will be
arbitrary, as determined by the exposed or modified region. For user desktops that
contain primarily 2D applications, turning off this property can save network
bandwidth. The default value is "1" - always snap the codec to tile boundaries.
Rgsender.MaxImageUpdateRate=int
Used to limit the number of image updates per second transmitted from the Sender
to the Receiver. The value is the maximum number of updates per second. If the
image update rate is too high, and using too much network bandwidth, the
MaxImageUpdateRate can be set to limit the number of image updates per second.
The default value is 0 - don't limit the image update rate.
Networking Properties:
Rgsender.Network.Timeout.Error=int
The timeout in milliseconds used to detect and disconnect an inactive connection.
The default value is 30000 milliseconds - thirty seconds. See Using Timeouts for
more details.
Rgsender.Network.Timeout.Dialog=int
The timeout in milliseconds used to display and wait on responses from input dialogs,
such as the authorization dialog and PAM authentication dialog. The default value is
15000 milliseconds - fifteen seconds. See Using Timeouts for more details.