HP xw4400 Workstation - Manual (Page 79)

Using Remote Graphics Software
71
Command Line Options
This section describes the options that can be specified on the command line of the
Receiver and Sender. In addition, many properties can also be set on the command
line.
RGS Receiver Command Line Options
The Windows Receiver (rgreceiver.exe) or the Linux/HP-UX Receiver
(rgreceiver.sh) command line options are:
[-directory [file] | -esdir serv1 [serv2 ... servN [-esdirsettings]]]
[-nosplash]
[-v | -ver | -version]
[-h | -help | -?]
-directory [file] starts the Receiver in -directory mode. If the optional "file" file
path is specified, then the file is opened and used to lookup systems assigned to the
user. If the "file" is not specified, the user is prompted to enter a path to the
directory file. See Starting the Receiver in Directory Mode for more details.
-esdir serv1 [serv2 … servN] starts the Receiver in enterprise service mode using
service 1 and service 2 through service N where serv1, serv2, and servN are the
hostnames or ipaddresses of the enterprise service. Setting the –esdir option allows
the Remote Graphics Software Receiver to lookup the systems assigned to the user
using a RGS Enterprise Service. See Using The Enterprise Service for more details.
-esdirsettings enables the Receiver to get and set the Receiver settings from the
enterprise service. If this option is used, -esdir must also be set.
-nosplash disables display of the splash screen when the Receiver starts.
[-v | -ver | -version] prints the Receiver's version information.
[-h | -help | -?] prints a listing of the various command line options, those that are
listed on this page.
RGS Sender Command Line Options
The Windows Sender (rgsender.exe) or the Linux/HP-UX Sender (rgsender.sh)
command line options are:
[-nocollab]
[-timeout value]
[-authtimeout value]
[-l logSetupFile]
[-v | -ver | -version]