HP xw4400 Workstation - Manual (Page 53)

Using Remote Graphics Software
45
Opening and Closing Connections
To connect to a Sender using the Receiver:
1. Enter the hostname or IP address of the Sender.
2. Press Enter or select the Connect button to connect.
The RGS Receiver Control Panel is used to perform the following tasks:
• Open a connection: To open a connection to a system, enter the hostname or
IP address of the system running the RGS Sender in the Hostname field.
Press Enter or select the Connect buttonto connect. The selector on the right
side of the text box displays a history of previously connected systems that
can be selected.
• Close a connection: To close a connection, select the Disconnect button.
• Authentication during a connection: When the Receiver connects to a Sender
the user must be authenticated and authorized. The Receiver displays
authentication dialogs where the user enters their credentials, such as
username and password. If the Sender validates the credentials and the user
is authorized, then the connection is established.
• Enable Setup Mode: Select the Setup Mode button to configure the local
Remote Display Window. In Setup Mode, the Receiver suspends mouse and
keyboard input to the remote system. This allows the user to move or resize
the Remote Window Display Window. The Remote Display Window should also
dim when Setup Mode is enabled. See Setup Mode and Hotkeys for more
information.
• Display Help: Click Help to display the online help. The online help is
displayed separately in a WEB browser, such as Internet Explorer or Mozilla.
• Display Program Information: Select the About button to display program
and copyright information.