HP xw4400 Workstation - Manual (Page 25)

Getting Started with Remote Graphics Software
17
First-time installs of the RGS Sender on Blade Workstations require installation via
the iLO Remote Console. This requires use of the administrative console in Setup
Mode (from the boot BIOS) to complete the RGS Sender installation. After the install
completes, return the iLO Remote Console Mode to User Mode. Please refer to the HP
Blade Workstation iLO documentation for further details about the iLO administrative
console.
Installing the RGS Sender and Remote Desktop
Using Microsoft Remote Desktop to remotely install the RGS Sender for Windows is
not supported. If attempted, the installation process displays an error message and
stops the installation process. If installing the RGS Sender on a HP Blade
Workstation, use the iLO Remote Console Mode in Setup Mode (from the boot BIOS)
instead.
Unattended Installations
If you need to install the Windows RGS Sender on several systems, please refer to
Creating Unattended Installers.
Installing the RGS Sender for Linux
Linux Sender Installation
1. Login as root.
2. Insert the HP Remote Graphics Software CD and mount the CD, if it is not
automatically mounted.
3. Go to the mount point of the CD, which is usually /mnt/cdrom and change
directories to lin32/sender.
4. Execute the following command:
./install.sh
5. The Sender will be installed to /opt/hpremote/rgsender.
6. Add the "rge" extension to the X Server configuration file. Edit the
/etc/X11/XF86Config , /etc/X11/XF86Config-4 or the appropriate XF86Config
file on your system for XFree86 X servers. Edit the xorg.conf file for X.Org X
Servers. In the Modules section of this file, add the following line:
Load "rge"
7. The Module section should read as follows:
Section "Module"
...
Load "rge"
...