HP xw4400 Workstation - Manual (Page 22)

HP Remote Graphics 4.2.0 User's Guide
14
appropriate senders. This software (based upon ALSA sound libraries and
JACK-Audio-Connection-Kit libraries) must be built and installed on the target
system as a part of the install.sh script. The install script assumes a supported
set of ALSA sound libraries from HP or Red Hat Enterprise Linux (release 4 or
greater) already exist on the platform. Only the JACK-Audio-Connection-Kit is
built during install and it requires ALSA sound library support.
Note: The files contained within hp_rgs_4_audiosupport.tar.gz can also be
built and configured for RPM package creation. See script rgs_audio_support
for details.
5. The Receiver will be installed into /opt/hpremote/rgreceiver. To start the
Receiver, execute the following command:
/opt/hpremote/rgreceiver/rgreceiver.sh
To start the Receiver in directory mode, execute the following command:
/opt/hpremote/rgreceiver/rgreceiver.sh -directory
6. Optionally, add the directory /opt/hpremote/rgreceiver to your PATH
environment variable.
7. Refer to Installing & Enabling Remote Audio to complete the Receiver
installation.
Installing the RGS Receiver for HP-UX
To install:
1. Login as root.
2. Insert the HP Remote Graphics Software CD and mount the CD.
3. Go to the mount point of the CD, which is usually /mnt/cdrom and change
directories to hpux-pa/receiver.
4. Execute the following command:
./install.sh
5. The Receiver will be installed into /opt/hpremote/rgreceiver. To start the
Receiver, execute the following command:
/opt/hpremote/rgreceiver/rgreceiver.sh
To start the Receiver in directory mode, execute the following command:
/opt/hpremote/rgreceiver/rgreceiver.sh -directory
6. Optionally, add the directory /opt/hpremote/rgreceiver to your PATH
environment variable.