HP 3PAR Application Software Suite for VMware Licenses - Manual (Page 51)

4. Click the HP 3PAR tab.
The information for all virtual volumes on the selected VM or Datastore is displayed.
Figure 27 Virtual Volume mapping
Viewing Volume information
After selecting a VM or Datastore, by default, all volumes on that VM or Datastore are displayed
in the Virtual Volumes tab (as shown in
Figure 28 (page 51) ).
The virtual volume information is divided into an upper and lower pane in the detail pane of the
interface.
•
The upper pane displays general volume information.
•
The lower pane provides the following details of Virtual Volumes (default view), Paths, and
Alerts.
The Upper pane
The upper pane of the Virtual Volumes tab is displayed as shown in Figure 28 (page 51) . RMV
detects whether or not there are multiple paths with different storage system serial numbers. The
plug-in displays the VM, Datastore, or Remote Copy groups using a Peer Persistence setup as active
or standby under the StoreServ column.
Figure 28 Viewing the upper pane of the Virtual Volumes tab
Viewing Virtual Volume mapping 51