HP StorageWorks X3000 Network Storage Systems - Manual (Page 87)

6 Cluster administration
HP StorageWorks X3000 Network Storage Systems support clustering; HP StorageWorks X1000
Network Storage Systems do not.
One important feature of HP StorageWorks X3000 Network Storage System models is that they can
operate as a single node or as a cluster. This chapter discusses cluster installation and cluster
management issues.
For information about installing, setting up, and configuring HP's High Availability (HA) Shared
Storage Solution bundles (the HP StorageWorks X3410 1-Node Network Storage System, HP
StorageWorks X3420 2-Node Network Storage System, and HP StorageWorks X3820 2-Node
Network Storage System), go to
http://www.hp.com/go/nas , click Entry File Services, click HP
Support & Drivers, select your product, click Manuals, and then click the link for HP StorageWorks
X1000 and X3000 Network Storage Gateway installation instructions.
Cluster overview
Up to eight server nodes can be connected to each other and deployed as a no single point of failure
(NSPOF) cluster. Utilizing a private network allows communication amongst themselves in order to
track the state of each cluster node. Each node sends out periodic messages to the other nodes; these
messages are called heartbeats. If a node stops sending heartbeats, the cluster service fails over any
resources that the node owns to another node. For example, if the node that owns the Quorum disk
is shut down for any reason, its heartbeat stops. The other nodes detect the lack of the heartbeat and
another node takes over ownership of the Quorum disk and the cluster.
Clustering servers greatly enhances the availability of file serving by enabling file shares to fail over
to additional storage systems if problems arise. Clients see only a brief interruption of service as the
file share resource transitions from one server node to the other.
X1000 and X3000 Network Storage System 87