HP NonStop G-Series - Manual (Page 93)

Troubleshooting
N1524A ACL Installation and User’s Guide for the NonStop S-Series Tape Enclosure — 527340-001
A- 3
Recovering from Errors
Error Recovery Procedures and Fault Symptom Codes includes additional procedures
that can perform by an experienced service technician.
Fault Symptom Codes (FSC)
Fault Symptom Codes appear in the Fault screen shown in Figure A-1 . Each FSC is
accompanied by a descriptive message and instructions for clearing the fault. If a fault
persists, look up the FSC in
Table A-2 and call the technical support representative. To
help identify the problem be sure to provide the FCS.
Table A-1. Error Recovery Procedures
ERP Number Procedure Detail
C Cycle power to the drive using the AC switch on the
front panel of the tape drive. Wait 30 seconds to
power on again.
D Turn off power to the tape drive and inspect
connectors and cables.
F Invalid operation. Select parameters correctly and try
again.
G Call technical support.
Table A-2. Fault Symptom Codes
FSC Displayed Message ERP
3001 Picker Tries Excd C¬
D¬ G
3002
Power Down to
Clear
Picker Tach
Errors
D¬ G
3003 Elevator Tach Errors D¬ G
3100 Picker Jammed
Power Down to Clear
C¬
D¬ G
3200 Elevator Jammed
Power Down to Clear
C¬
D¬ G
5002 All LTOs / Slots Empty
Press Enter to Clear
F
5003 All LTOs / Slots Full
Press Enter to Clear
F