HP NonStop G-Series - Manual (Page 41)

Installing and Configuring the Tape Drive
N1524A ACL Installation and User’s Guide for the NonStop S-Series Tape Enclosure — 527340-001
2- 11
Set Default (Restricted)
Set Default (Restricted)
This option resets all of the preceding configuration options to their factory
defaults. Under no circumstances should this option be used.
Table 2-2 summarizes the configuration and default settings for the tape drive.
Other possible settings are shown in the second column.
Table 2-2. Tape Drive Configuration Options
Option Settings Default
Data Format Density: Auto Selection
Compression: Enable, Disable
(Enable at 10.0 only)
Auto
Auto
SCSI Lib Bus Parity: Enable, Disable
Lib Bus ID: (SCSI ID)
LTO1 Bus ID: (SCSI ID)
Enabled
3
5
Library Mode Random, Seq. LTO1
Sequential Mode: Normal,
Recirculate
Sequential
Normal
Element Base Transport: NNNN (hex)
Storage: NNNN (hex)
Transfer: NNNN (hex)
0000
0001
00F0
Identification Vendor ID: OVERLAND
Product ID: LoaderXpress
HP
N1524A
Date DD,MMM,YYYY Current Date
Time HH,MM Current Time
Baud Rate [TSI CE use only] 38400
Serial Number NXNNNNNNN 999999999
Unload Mode Implicit, Explicit Implicit
AutoClean Mode Disabled, Enabled Disabled
Negotiation Negotiation Mode: Do Not
Initiate, Initiate
Transfer Rate: Sync. 10 MB/sec
Do Not Initiate
10 MB/sec