HP NonStop G-Series - Manual (Page 37)

Installing and Configuring the Tape Drive
N1524A ACL Installation and User’s Guide for the NonStop S-Series Tape Enclosure — 527340-001
2 -7
Setting the SCSI ID
5. The Library SCSI ID is set to 3. If the bus ID needs to be set to 5, check that
the cursor is next to line 1, and press the down button repeatedly until the
display scrolls, as shown in Figure 2-7 .
Figure 2-6. Set SCSI Menu
Note. In Figure 2-6 , note that the cursor is next to line 1, and that line 2 is indented, indicating
a two-tiered menu. The scroll buttons work on two levels in this type of menu, which is typical
of many menus under Configure. First-level navigation: When you press the down button, the
cursor moves to line 3. Pressing the down button again, you will scroll down to Bus ID. If you
press the up button, the cursor moves back to line 1.
If you press Enter while the cursor is next to line 1 (or line 3), the scroll buttons operate on the
second level. As a result, the cursor moves next to line 2 (or line 4), and a down arrow appears
at the end of line 4, indicating a list of options that you can view by scrolling.